Click image to view full size image
Description:
hss slitting saw, metal slitting sawMaterial:M2(HSS-DMo5), M35(HSS-Co5%)
coating:vapo, tin, ticn, altin
size:175~500mm
hss sliting saw/sawblade(HSS-DMo5, HSS-Co5%)
Material:M2(HSS-DMo5),M35(HSS-Co5%), offered by baosteelenterprise
Brand:Pioneer
Application:whichis made of high-speed steel, used for cutting ferous pipe, such assteel pipe, stainless steel pipe.
Surface treatment:Vapo, TiN, TiCN,TiAlN
Toothform: A/AW/B/BW/HZ
aboutCOATING
Circular sawblade can be coated (PVD or Vapo coating) to improve theperformance, increase the life and lower the cuttingtime.
So it is veryimportant to choose a good coating.The most common PVD coating isTiN, TiCN, AlTiN.
VAPOCOATING
DEscriptION
| Vaporized circularsaw blade have a surface treatment by applying oxide coating bysystem.The special advantage are sliding ability and increasedabsorptive capability for reception of the colling luquid andavoiding the sticking up the material. | |||
SPECIFICATION | ATTRIBUTE | THICKNESS | HARDNESS | FRICTIONCOEFFICIENT |
vaporized | 5-10μm | 800-900HV | 0.65 | |
TINCOATING
DEscriptION | Titanium Nitride,which allows saw cutting at much higher speeds than with HSS SteamTreated saw blades and are recommended for cutting steel tubes andprofiles | |||
SPECIFICATION | ATTRIBUTE | THICKNESS | HARDNESS | FRICTIONCOEFFICIENT |
PVD | 2-4μm | 2200-2400HV | 0.55 | |
TiCNCOATING
DEscriptION
| This is a multi-layer coating witha low friction coefficient that offers an excellent finish at veryhigh cutting and feed rates. It can be used for hard steels (800 –1000 N/mm2), for copper and brass alloys and for extremely abrasivematerials where the phenomenon of “chip welding” can be aproblem. | |||
SPECIFICATION | ATTRIBUTE | THICKNESS | HARDNESS | FRICTIONCOEFFICIENT |
PVD | 2-4μm | 3000-3200HV | 0.2 | |
AlTiNCOATING
DEscriptION
| Suitable for stainless steels,materials with high tensile strength and abrasive materials such ascast iron, silicon aluminum alloys, brass and copper. Due to itslow friction coefficient this coating is also suitable fordry-cutting at relatively high cutting speeds. | |||
SPECIFICATION | ATTRIBUTE | THICKNESS | HARDNESS | FRICTIONCOEFFICIENT |
PVD | 3-4μm | 3300-3500HV | 0.3-0.4 | |
hss slitting saw(HSS-DM5, HSS-Co5%)
